These are U.S. made brass eyelets with a coyote brown epoxy finish. These will fit into 1/4” diameter holes. The 8-8 size is perfect for joining two layers of .060 or .080 material together. They will also allow you to join up to .080 to .125 materials. They are not long enough to join .125 to .125 materials. Please check out our tooling section to find some low-cost eyelet setting options.
Posted by Unknown on 16th Nov 2015
Decided to try these out after only using black oxide eyelets for the past 3 years. No matter how slow or fast you press these eyelets, the cheap paint chips off off of the rolled side. I even tried applying oil to my die set to lubricate the process. Same result. If you don't care how the back of your eyelets look than these are fine. Otherwise, don't waste you time or $$ on these.
Reply from Patrick at DIY: We can't make it right if you don't contact us. We'll gladly exchange or refund any product your not satisfied with.
All prices are in USD.